Crank position sensor is usually installed in the distributor, the control system is the most important one of the sensors. Its role is: detecting the engine speed, so-called rotation speed sensor; detects the piston top dead center position, it is also known as the only point sensor, including the detection of each cylinder for controlling the ignition TDC signal for controlling sequential spray oil first cylinder TDC signal
2013年8月25日星期日
Automotive Sensor
Automotive automotive sensor input device of the computer system, that the car is running in a variety of conditions information, such as speed, temperature of various media, such as engine operating conditions, lose electrical signals into the computer so that the engine is in the best working state. Vehicle many sensors, sensors to determine when a failure occurs, should not only consider the sensor itself, but should be considered faulty circuit as a whole. Therefore, when troubleshooting, in addition to Cooling Temp Sensor, should also check the wiring harness, connectors and sensors and electronic control unit between the relevant circuits. Automotive electronic control devices are widely used, each electronic control devices including sensors, electronic control unit, the executing agency of three parts. It is the use of sensors to monitor the working conditions of vehicle-related assembly, and the relevant information to the electric element, electronic control unit through the analysis, calculation, judgment, to send commands to the actuator, so that the working conditions of the relevant assembly to achieve the best . Automotive parts Shaft Position Sensor is sensing an important electronic device configured with the car getting higher and higher, the development of automotive sensors and more advanced.
订阅:
博文评论 (Atom)
没有评论:
发表评论