Measurement of motor bearing temperature, the sensor junction box installed in the appropriate position of motor,Tighten the connecting screws, connecting wire.The temperature sensing element transducer (probe) is inserted into the screw hole in the vicinity of the motor bearings (such as motor casing, shaft casingdrilling), and tighten the mounting nut.The junction box of Shaft Position Sensor is opened, will leadcable connected, theboxcover,willleadto thecable to designatedlocations and intrinsically safe type two meter connectioninstallation lead atCoolant Temperature Sensor intervals of 300mm head is fixed by binding, wire spring tubebending radius is not less than 60mm, lead too long can pull ring in the right place,and far from the heating equipment.
If you choose "not moving" nut installation, the installation must first install theprobe part, then mounted junction box
没有评论:
发表评论